Goal: Use my “franks_env.ini” file to build an image using Liligo-rtl_433 and add support for a BME280 sensor. I have a lilygo LORA32 915 flashed up and receiving data from my weather station just fine. My first step was to create the franks_env.ini so I could experiment in building my custom flas…

[image] gfrankg: I am using these icons to build and send my flash if that matters. Hi Frank, Instead of trying with the default_envs or bottom build and upload options, which all require commenting or uncommenting different default_envs, can you see the PlatformIO icon on the left side - th…

Hello, Have you selected the board in the bottom bar: [image] Also, as you are using the extends PIO command, you may remove all the definitions that are already present in the original environment

Thanks for getting back so quickly! I just see “Auto” at the bottom, but I am able to erase and reflash my board no problem. [image] As far as that “extends” command… I am not entirely sure what that does anyway. Don’t seem to matter if I remove it. Now if I go into the environments.ini and m…

Hold up… trying again with this… [image]

[image] gfrankg: As far as that “extends” command… I am not entirely sure what that does anyway. Don’t seem to matter if I remove it. Now if I go into the environments.ini and make a basic change there, that will be written to my board… I just can’t seem to get the complier to follow the directi…

Removed the extends command. same result. I keep looking for the gateway name on my board display to change based off of: ‘-DGateway_Name=“Franks_Gateway-NEW!”’ but it’s not updating. That line in franks_env.ini should over right the default stored in the environments.ini correct?

Add at top of your file [platformio] default_envs = lilygo-rtl-FG

I get this error: Warning! Ignore unknown configuration option default_envs in section [env:lilygo-rtl-FG] [env:lilygo-rtl-FG] default_envs = lilygo-rtl-FG platform = ${com.esp32_platform} board = ttgo-lora32-v21 ; ~/.platformio/packages/framework-arduinoespressif32/variants/…/pins_arduino.h …

Added brackets [default_envs = lilygo-rtl-FG] compiling now

Still seems to be using this config from the enviorment.ini file… If I make changes here… they ARE written to my board. [env:lilygo-rtl_433] platform = ${com.esp32_platform} board = ttgo-lora32-v21 ; ~/.platformio/packages/framework-arduinoespressif32/variants/…/pins_arduino.h board_build.par…

I am using these icons to build and send my flash if that matters. [image] going to try a stripped down env.ini file next. [env:lilygo-rtl-FG] [default_envs = lilygo-rtl-FG] platform = ${com.esp32_platform} build_flags = ${com-esp32.build_flags} ‘-DGateway_Name=“Franks_Gateway-NEW!”’ ‘-DM…

Theengs community Home Compatible Devices Community Shop Sponsor 🤍 Github

Theengs and OpenMQTTGateway

Platformio Portable Configuration File

gfrankg January 23, 2024, 10:51pm 12

Appreciate the support… but still can’t figure out what I am missing.