Brennenstuhl radio socket commands

Theengs OpenMQTTGateway Radio frequencies gateways 315mhz, 433mhz, 868mhz
1

Hi there,
I got new radio sockets and I can’t get the commands to work.
Here is what I receive from the remote:

home/OpenMQTTGateway/433toMQTT/protocol 5
home/OpenMQTTGateway/433toMQTT/bits 24
home/OpenMQTTGateway/433toMQTT/length 513
home/OpenMQTTGateway/433toMQTT 3354476
home/OpenMQTTGateway/commands/MQTTto433 3354476
home/OpenMQTTGateway/433toMQTT/protocol 5
home/OpenMQTTGateway/433toMQTT/bits 24
home/OpenMQTTGateway/433toMQTT/length 516
home/OpenMQTTGateway/433toMQTT 3354476
home/OpenMQTTGateway/commands/MQTTto433 3354476

So my command I would send is:

mosquitto_pub -u ** -P ** -t home/OpenMQTTGateway/commands/PLSL_515/433_5/RFBITS_24 -m 3354476

I can’t control the socket with the command above.

2

The sockets are really weird. The intercepted signal is always different. Any hints or are they not useable?

3

I usually press the button several times with a short press and check the received value that comes the more. Try with this value on OMG and if it doesn’t work i test the others.

4

Do I need to change the pulse length or is sending the /433_5 enough as parameter?

5

You should not need it, could you post what you are seeing in your broker putting in evidence the “different” messages?