Brand new setup, I’ve tried the 0.9.8 firmware as well as 0.9.7 and both seem to have an exception reboot loop on the first scan (~2 sec uptime). HM-10 firmware is 709 and the serial pass through sketch seems to show expected information to the scan. I’m guessing it has to do with one of the devices seen, but I’m not sure how to go from the exception to trace in the code
--------------- CUT HERE FOR EXCEPTION DECODER ---------------
Exception (28):
epc1=0x4000bdc8 epc2=0x00000000 epc3=0x00000000 excvaddr=0x00000000 depc=0x00000000
stack>>>
ctx: cont
sp: 3ffffd10 end: 3fffffc0 offset: 0190
3ffffea0: 3fff0df4 3fff07ac 3fff0784 40203ef3
3ffffeb0: 3fff0784 3ffe8962 3fffff10 3fff3204
3ffffec0: 3fff2f5c 00000012 00000000 3fff0df4
3ffffed0: 00000042 00000001 3fff0784 40202010
3ffffee0: 40283738 423a3731 3fffff10 3fff0df4
3ffffef0: 00000042 00000001 3fff0784 40205da0
3fffff00: 00000042 3fff0784 3fff0704 40209d70
3fffff10: ffffffa8 00000000 80c6a7f0 3fff2f5c
3fffff20: 0012001f 00000000 40003031 a9ba5e35
3fffff30: 82000000 3f003861 3fff0b30 8220d46b
3fffff40: 3fff3204 0011001f 00ff0b30 3fff31bc
3fffff50: 0032003f 00ff0bb4 3fff166c 40229089
3fffff60: ffffffa8 00000020 3ffe8564 402275c2
3fffff70: 3fff0bbc 00000001 0000002c 00000000
3fffff80: 3ffe85cc 3fff0df0 0000db78 40209ef0
3fffff90: 3fffdad0 00000000 3fff1070 3fff10b0
3fffffa0: 3fffdad0 00000000 3fff1070 4021d05c
3fffffb0: feefeffe feefeffe 3ffe8714 40101485
<<<stack<<<
--------------- CUT HERE FOR EXCEPTION DECODER ---------------