Hi guys, I got 3 boards(2 ESP32 & 1 nodemcu) flashed OMG 0.9.6(uploaded from PlatformIO with some config modifications). several days ago I tried to flash 2 of them(1esp32 & nodemcu) with the new release 0.9.7 code base, after that I kept failing to send RF signal. Have you guys encountered this p…

Enable transmit outside of CC1101 1technophile:development ← 1technophile:rf-transmit-for-non-CC1101-emitter opened 12:37AM - 27 Jul 21 UTC (UTC) [1technoph…

[image] lkisme: My boards keep shutting down and restart( sometimes they don’t) with 0.9.6, so I want to try the 0.9.7 release. Hi, It may be due to new parameters introduced with wifimanager. Could you try to erase the flash memory of the boards and upload them again. So as to erase the fl…

Hi, Thanks for reply. I did try to erase the flash memory with the tool you mentioned, and do the wifi setting all over again(on the ESP32 board). I may not mention earlier, all other “receiving” function worked well while the “sending” function doesn’t work. [WX20210725-230126@2x] I just use N…

Would it be possible to share your configuration parameters, user_config.h and config_rf.h Or the env if you are using platformio.

@NorthernMan54 any ideas here ? Do we have to activate the sender now : Example: mosquitto_pub -t "home/OpenMQTTGateway/commands/MQTTto433" -m '{"active":true}' Before sending ?

@1technophile With a single module enabled, it is always enabled so no need to activate.

with the ESP8266 board, I was using the release firmware downloaded from github, so no configuration changed.As you can see in the screenshot, it’s nodemcuv2-rf-firmware.bin

And FYI, the “sending” action I took is by sending msg directly to mqtt through mqtt client, so the root cause here may not be the wifi setting ?

Any logs from the device while you are sending ? Also are you able to monitor the transmission with a RTL-SDR ? I find it is tricky to get the correct signal and takes a few tries comparing the signal from openmqttgateway with the actual remote/device.

I reproduce the issue, let me dig into it

Theengs community Home Compatible Devices Community Shop Sponsor 🤍 Github

Theengs and OpenMQTTGateway

ESP32/ESP8266 fail to send RF signal

Theengs OpenMQTTGateway Radio frequencies gateways 315mhz, 433mhz, 868mhz

1technophile July 27, 2021, 12:07am 11

Found it,
mySwitch.enableTransmit(RF_EMITTER_GPIO);
is activated for CC1101 only. I will publish a PR soon and a release after