Is there a way to either go to AP mode or erase the saved configuration on the Lilygo LoRa boaed?

Is it possible to erase the config in OpenMQTTGateway without downloading new firmware? I know that some boards support a long press on a defined button but not the board I’m using, LoRa32 V2.1_1.6. I see references in the code for support of sending erase and restart commands in connectMQTT() but the callback function doesn’t seem to support it.

Any help would be appreciated. What I’m trying to do is build a copy of the binary used by the lilygo-rtl_433 binary upload.

Hi @drogge47,

Is this what you are looking for?

That did it DigiH. Thanks for the pointer.